| 引用本文： |
-
韩彪,王启明,郑广林.酒精废水厌氧生物处理工程[J].广西科学院学报,2010,26(2):159-161. [点击复制]
- HAN Biao,WANG Qi-ming,ZHENG Guang-lin.The Engineering of Anaerobic Treatment for Alcohol Production Wastewater[J].Journal of Guangxi Academy of Sciences,2010,26(2):159-161. [点击复制]
|
|
| 摘要: |
| 采用上流式厌氧污泥床(UASB)反应器对糖蜜酒精废水进行厌氧生物处理。UASB反应器接种污泥采用厌氧污泥,反应器启动后,当污泥粒径增大成1mm的颗粒污泥后,能在较短的时间内快速提升负荷,缩短启动所需的时间。达到设计负荷后,UASB出水COD降低至8000mg/L,pH值在7.1左右,处理效率达82%。 |
| 关键词: 废水 厌氧处理 上流式厌氧污泥床(UASB) 颗粒污泥 |
| DOI： |
| 投稿时间：2010-03-12修订日期：2010-04-18 |
| 基金项目: |
|
| The Engineering of Anaerobic Treatment for Alcohol Production Wastewater |
|
HAN Biao, WANG Qi-ming, ZHENG Guang-lin
|
| (Guangxi Environmental Protection Institute of Science and Engineering Center, Nanning, Guangxi, 530022, China) |
| Abstract: |
| UASB reactor was used to treaf wastewater from alcohol production.The inoculation sludge in the UASB was anaerobic sludge.After the start-up of reactor and the particle size of granular sludge grew to 1mm,reactor can upgrade the load in a short time to shorten the staring time.When the designed load is reached,the effluent COD is 8000mg/L,pH value is about 7.1,the removal rate is 82%. |
| Key words: wastewater anaerobic treatment UASB granular sludge |
